1. When do I need a sanitary permit for a POWTS?
A sanitary permit is required when:
1) A property owner desires to build a structure in an area where public sanitary sewer service is not available.
2) Anytime a property owner desires to have, or is required to have, an existing failing POWTS replaced.
3) Anytime a property owner proposes a significant change to the primary living structure or place of business. Land divisions, conditional use requests, and change of use (for business establishments) may also require an upgrade or replacement of the existing POWTS.
2. How do I get a sanitary permit?
You can get a State sanitary permit by following the steps outlined on the “Obtaining a Sanitary Permit” page of this website.
3. My septic system is not working anymore. How do I get it replaced with another septic system that works?
Go to the Obtaining a Sanitary Permit portion of this website for this procedure. If you have further questions you can contact this department.
4. Does it matter if I do all my laundry in one day?
There are very few things that you could do that are more detrimental to your Private Onsite Wastewater Treatment System (POWTS). It is one of the quickest ways to cause your POWTS to fail.
When people do all their laundry in one day, the high (peak) flow will cause the drainfield to go anaerobic (without air). Your POWTS performs best in aerobic conditions. In aerobic (with air) conditions there are a lot more bacteria that are working to digest the organics (among other things) in the wastewater.
The peak flows that flow into the septic tank from the home cause the settled solids to re-suspend themselves in the wastewater. During re-suspension these solids get pushed out of the septic tank and end up in your piping network or drainfield. When these additional solids end up in the drainfield, it will accelerate the failure rate of the drainfield. In other words, the drainfield will fail much quicker than a POWTS that does not experience frequent peaks flows.
All septic tanks designed from about 1978 to present were designed to allow for a 24-hour settling period for any solids or suspended solids entering the tank. By creating excessive peak flows the solids settling cycle will be short-circuited and cause most suspended solids to leave the septic tank too soon.
To help minimize the peak flow effects generated from the laundry process, homeowners should consider purchasing water conserving, low flow front load wash machines. They typically will use about 1/3 of the amount of water, per load, as the standard top load wash machines.
5. How long are soil tests (perk tests) for Private Onsite Wastewater Treatment Systems (POWTS) good for?
The “perk” test method of testing for POWTS suitability has been replaced since 1994 with a more accurate and descript means of soil and site evaluation. Now the soil testing procedure is done by means of a morphological evaluation.
After the soil and site evaluations have been conducted by the soil tester the results of that soil and site evaluation are to be sent to the County reviewing authority.
After the soil and site evaluations have been reviewed by the county reviewing authority, and are found to be acceptable for completeness, the evaluations are then filed for use with a future sanitary permit for the property tested. The soil and site evaluations (soil tests) are good for as long as the administrative rule that governs them remains in affect. If there is a significant rule change that effects the soil and site evaluation process or results of previously completed tests then a new test may have to be done.
6. Why do I need a sanitary permit?
A sanitary permit is necessary to ensure that a proposed Private Onsite Wastewater Treatment System (POWTS) installation will meet the minimum standards specified in the Wisconsin Administrative Code that governs this issue. These standards specify a POWTS separation requirements to seasonal water table, wells, lot lines, structures, water lines and mains, etc. It also identifies treatment methods and products that are acceptable for use in Wisconsin POWTS and the manner in which they should be installed.
7. How long is a sanitary permit good for?
A State sanitary permit is current or valid for a period of 2 years from the date of sanitary permit issuance. In most cases a State sanitary permit can be renewed prior to the expiration date of the permit. You can contact this department if you would like to know more about this process.
8. I have heard of County sanitary permits – When are these issued?
County sanitary permits are issued when unique situations arise where a State sanitary permit issuance is not warranted. For example: a property owner would like to add a room or rooms to an existing building where a State sanitary permit had been issued before and the POWTS has been installed for more than 2 years. During the “addition” building process, it will be necessary to disconnect the existing POWTS from the structure for a period of time and then reconnect to the existing POWTS to the structure via the new building addition.
Another example might be a property owner wants to put up an outbuilding and also wants to put a bathroom in it for a convenience to themselves. A County sanitary permit can be issued so long as the existing POWTS is a code compliant installation previously inspected by Staff of this department.
For further details of County sanitary permit issuance and when they may be necessary, you can contact the Kenosha County Department of Planning and Development.
9. Do mound systems really work?
For some reason, there appears to be a myth that exists about mound systems not working. You should know that mound systems work every bit as well as an inground (conventional) POWTS. The primary difference between the two systems is that mound systems are pressurized above-ground systems and the conventional inground system is below ground and typically not pressurized.
As far as system performance is concerned, a pressurized system typically will perform better than one that is not, because the wastewater is dosed over the entire absorption area versus being distributed over a small area as in the conventional gravity system.
10. Can anybody install a Private Onsite Wastewater Treatment System (POWTS)?
A POWTS can be installed by those individuals who have obtained the license classifications of Journeyman (JP or JPRS) and Master Plumber (MP or MPRS) designations awarded by the State of Wisconsin Department of Commerce. Only those who have obtained the classification of Master Plumber (MP or MPRS) can obtain a State sanitary permit. All Wisconsin licensed plumbers have certification cards that list their credential number. You can enter this credential number on the State of Wisconsin Department of Commerce licensing bureau website to find out whether the plumber is still in good standing.
If they do not have these credentials then they will not legally be able to install a POWTS in the State of Wisconsin. You can check the yellow pages for POWTS installers or contact Kenosha County Department of Planning and Development for a list of POWTS installers.
Go to “Contacts” page of this website for licensing web link.
11. Can I have a food waste grinder installed in my home even though I have a POWTS?
Depending on who you ask this question to, your answers will be varied in response. Some will say that a food waste grinder should never be installed and some would say it is acceptable. Those that would say that it is acceptable would say so with a few conditions.
If a grinder were added to the kitchen sink, the disposal should be used sparingly only. Also, if you are intending to put in a disposal, you should let your POWTS installer know so that a modification can be made to the proposed treatment tank. The treatment tank should at least be two-chambered and have an effluent filter installed on the septic tank outlet. You should give serious consideration to oversizing the septic tank beyond the minimum Code requirements.
By following these simple procedures your POWTS may not experience premature failure due to the additional settling time provided by your treatment tank.
12. How often should I pump my treatment tank(s)?
See the “Septic Tank Maintenance” section of this website.
13. Are two-chamber or multi-chamber septic tanks better for your POWTS than single chamber tanks?
You will find that a two-chamber or multi-chamber treatment tank will do a much better job of filtering out solids and suspended solids before wastewater leaves the tank on its way to the drainfield. This filtering ability is enabled because of separate chambers that are contained within the treatment tank that reduces the amount of disturbance caused by peak flows to settled solids within the tank. Because of this disturbance reduction, fewer solids will leave the tank, which then improves drainfield lifespan.
14. Does having a two-chamber septic tank help to reduce the maintenance frequency of my effluent filter?
In this particular case, bigger does appear to be better. Having a treatment tank with greater capacity than the minimum required by code, along with a multi-chamber tank, seems to reduce the maintenance frequency of effluent filters when compared to those in single chamber tanks.
15. How often do I have to service the effluent filter in my septic tank?
Service frequency of the effluent filter is based on each household’s wastewater generation habits. Some households may be able to go three years between service events and some might be monthly. It will be trial and error for the individual property owners to see what works for them.
Effluent filter alarms are available for people who are interested in that extra degree of security for that “just in case” event of sewage backing up into the basement when the effluent filter is clogged. A clogged filter will restrict the amount of wastewater leaving the septic tank, which causes the wastewater level to rise in the septic tank.
When the wastewater level rises above its normal flow level it will begin to back up into the piping network coming from the structure.
16. Is there financial assistance available for property owners whose POWTS has failed and needs to be replaced?
You can find out more about available funding for replacement POWTS by going to the Wisconsin Fund Private Onsite Wastewater Treatment System Replacement or Rehabilitation Financial Assistance Program page of this website and also visiting the Housing Authority page of this website.
17. I see advertisements that say “if I buy this product I can reduce the pumping cost for my septic tank.” Does this really help?
If the manufacturer of the product can state that the end bi-product results in carbon dioxide and water, then it would be a product that would be beneficial to your septic system. If the manufacturer cannot make that claim then it would not be a product worth purchasing, with one exception. That exception would be if the digesting agent could consistently be evenly distributed within the drainfield without having to go through the septic tank first. If that could be done then the agent would more than likely be of some benefit to your POWTS.
There typically are more than enough bacteria in the wastewater generated daily to do a sufficient job of digesting the biodegradable material in the waste stream. There comes a point where the solids that remain in the tank can no longer be digested and will not be able to undergo further digestion.
If you use strong cleansers conservatively and feel the need to add a digesting aid to assist the bacteria in your septic tank you could add several cakes of yeast to boost the digestion process for a while.
The statement of “saving costs” on pumping your septic tank does not appear to make sense for people living in Wisconsin. All septic systems installed within the last 25-30 years in the State of Wisconsin are required to have the septic tanks pumped at least every 3 years. Where would the cost savings come from?
18. How are Private Onsite Wastewater Treatment Systems (POWTS) sized?
POWTS are sized based on the number of bedrooms in a structure or proposed structure for residential applications. Commercial sizing will not be discussed. Typically the sizing is based on 75 gallons per person per day with a proposed occupancy of 2 people per bedroom. With this standard in mind, the average 3-bedroom home will have a calculated daily wastewater flow (DWF) of 450 gallons per day.
After determining the DWF the POWTS installer can size the necessary treatment tank(s) properly. After reviewing the soil and site evaluation report, that was performed by the certified soil tester, the installing plumber can then determine the minimum size of absorption field required which is based on the soil load rate that is specified on the report form.
19. I recently purchased a home and I had a septic system evaluation done at the time of purchase. I would like to do an addition and also some remodeling of the home. Can I use this septic system evaluation to get my Zoning Permit?
Most often the answer to that question is “NO”. The primary reason for that is there is no code language currently written that states what would be considered a thorough septic system evaluation for real estate transactions.
You will often find with the proposed renovations to the structure that you will have to have another evaluation done to find out if the existing system will meet the Administrative Code or Sanitary Ordinance governing septic systems.
Quite often, when these system evaluations are done, they may not meet the minimum separation to groundwater table. This evaluation will include a look at the soils in which the septic system was previously placed.
If after this type of septic system evaluation was done and the existing septic system could not meet the minimum groundwater separation requirements, the septic system would have to be replaced with a code-compliant septic system.
To replace the existing septic system with a new system refer to the Obtaining a Sanitary Permit portion of this website.
20. I have a mound POWTS and I want to landscape it. Can I plant trees and shrubs on or around it?
If you want to put plantings on or near your POWTS you should plant species of plants that have a herbacious root system.
If you select plants that have a woody root system and plant them very close to, or on top of, the absorption field it will experience root problems.
The roots from this plant group tend to grow or migrate in the direction of a moisture source and work their way into the piping network. Once inside the network the roots begin to clog the piping. Given sufficient time the roots will cause system failure.
The alternative to a woody root plant species could be flowers or wildflower seeding.